Weekly Report 22Apr2011
From RHESSI Wiki
RHESSI Albedo Image Test
RHESSI Clean Imaging techniques were used to image a large number of flares. For each flare three different detector combinations and two different energy bands were used. The following parameters were used: The flares used were decided upon by the RHESSI response in the 25keV-50keV bands.
- Time: Decided by the peak of the 25keV-50keV energy band for each flare
- Energy: 12keV to 25keV, or 25keV to 50keV
- Detectors: 1 to 9, or 1 to 5,or 6 to 9
- Pixel Size: 2 arcsec by 2 arcsec
- Image Size: 128 pixels by 128 pixels
- Clean Beam Width Factor = 2
Clean images were made with each for each energy band with each detector combination. For each image the centroid of the source was measured, the total flux in the image was measured, and the standard deviation in the x and y direction for each source was measured. Using these measurements the plots below were made.
The new analysis below was done because of the last set of data analysis showed an asymmetry in the distribution of flares. One third of the flares were in the negative heliocentric x hemisphere with two thirds in the heliocentric y hemisphere. This turned out to be an analysis issue with the selection of the heliocentric X position. The selections were done using all detector combinations instead of thee position for the flare. This lead to discrepancies in the flare position.
The plot below shows the actual flare position of all flares which reached the minimum flux value required in black. The flares which were actually selected are in green. These met additional criteria for the flux in the 35keV to 50 keV energy band.
The plot shows that there were more flares selected in the positive heliocentric positive x hemisphere.