Effects of Flares on Solar p-modes

From RHESSI Wiki

Jump to: navigation, search


Nugget
Number: 408
1st Author: Maria-Cristina RABELLO SOARES
2nd Author: Frederic BAUDIN
Published: 26 April 2021
Next Nugget: Non-equilibrium ionization
Previous Nugget: Subsecond Spikes in Solar Flare X-ray Flux as Seen by Fermi GBM
List all



Contents

Introduction

The interior of the Sun supports a huge array of standing waves, the celebrated p-modes of helioseismology. These oscillations contain energy, in varying amounts, and several attempts have been made to observe whether solar flares modes can contribute to their excitation. This was indeed proposed in 1972 by C. Wolff (Ref. [1]) We have now applied the modern technique of ring-diagram analyis to look for the impact of flares on the mode amplitudes (Ref. [2]).

Pitfalls: Firstly, we analysed several factors that affect the observed amplitudes of high-degree solar p-modes, namely line-of-sight limitations, strong magnetic fields and gaps in the observations. If not taken into account, the apparent changes in the observed mode amplitude could be misinterpreted as an effect of a flare. Care is required not only in analysing the flaring region but also in the comparison one that is used as the quiescent state to infer the change in the mode amplitude due to the flare in an ever-changing Sun.

The Halloween flare: Then, we investigate a single event, the largest flare in the space age (the "Halloween Flare" SOL2003-10-28T11:00), using solar magnetic-field data from MDI instrument. Contrary to earlier results (Ref. [3]), we did not find any amplification (larger than ≈5%) in the inferred mode amplitude during the flare, as opposed to the reported increase of more than 100%. This difference could be in part result from the lack of a correction for the line-of-sight effect as the observed region rotates in relation to the observer in the earlier work;. we found an increase of as much as 60% in the mode amplitude during the flare, when not taking this into account. On the other hand, we found that the scatter in the fitted mode amplitudes increases as the duty cycle decreases, especially when it is lower than 80%.


A statistical approach

Using HMI data, the analysis was applied to the regions corresponding to the flares observed during the high activity phase of Cycle 24 based on the Heliophysics Event Knowledgebase (HEK). The HMI data cubes were divided into three sets:

  1. "Strong Flares": those with peak flux larger than 1200 erg/cm2/s and/or GOES class M or X,
  2. "Weak Flares": with peak flux between 10 and 60 erg/cm2/s, and
  3. "Without Flares": where no flare was detected.

The first set is used as a comparison to the results of the strong flares in the second set. Figure 1 shows the distribution of the mean magnetic field of each tracked region (MAI) for each data set at 10 G intervals. Most of the Strong Flares regions (75%) have an MAI smaller than 200 G and only 10% larger than 290 G.

The fact that flares occur in low MAI regions could be surprising. We can however speculate that the complex geometry (e.g., inclination, distant loop footpoints etc) of magnetic structures at the origin of the flares can explain the low value of the MAI.

Figure 1: Number of five-degree HMI data cubes for each data set as a function of the Magnetic Activity Index (MAI). The Strong Flares are shown as red circles and the Weak Flares as blue triangles. A smaller number of HMI regions for the Weak Flare (green stars) and Without Flare (black circles) sets were selected, with MAI values evenly distributed, to a number closer to the Strong Flare set.


Amplitude difference between regions with and without flares

We used an average of 20 quiet regions (with MAI < 1 G) at each disc position as a reference, AQ, to take into account of the line-of-sight effect.

In Figure 2 we compare the relative mode amplitude obtained in the Strong (SF) and Weak Flares (WF) set with those in the Without Flare set (WO) to look for an effect of a flare on the mode amplitude. However, to take into account the effect of strong magnetic fields on the mode amplitude, we also need to compare regions with similar MAI.

Figure 2: Mean relative amplitude difference between Weak ("WF": left column) and Strong ("SF": centre column) compared to Without Flares ("WO") set with MAI = 45 ± 8 G. The different colours represent different mode order n: 0 (red), 1 (blue), 2 (green), and 3 (orange). The Without Flare set was divided into three sets and the mean relative amplitude difference between them was calculated as an indication of systematic variation in our analysis (crosses, diamonds and squares). At the top left is shown the smallest and largest error bars. Right column: The median of the MAI in the neighbourhood of the analysed regions, divided by the MAI of the target, MAI0, as a function of distance from the target represented by full circles: Without Flares in black, Strong Flares in red, and Weak Flares set in blue. The small crosses and diamonds are the first and third quartiles, respectively.

The differences of relative amplitude (Figure 2 left and centre panels) should be small since these amplitudes are observed in regions with similar MAI. However this is not the case, especially for regions with low MAI (as in Figure 2). In regions with Strong Flares (centre column), the mode absorption is even larger than for Weak Flares (left column).

A possible explanation for the mode-amplitude decrease observed in these flaring regions could be due to the strong magnetic fields usually present in and around a flare, more so for the Strong Flares.

Looking for a similar effect in our data, we show the median MAI in the neighbourhood (within 14°) of the regions analysed as a function of distance to its centre (rightmost column in Figure 2). It is larger for the Strong Flare set (red) than the Weak Flare set (blue) and both are much larger than the Without Flare set (black).

The effect of an active region on a nearby quiet region

The mode amplitude in a magnetically quiet tile is affected by a nearby active region by as much as 20% in its observed amplitude, as shown in Ref. [4]. The mode amplitude variation for 5° regions was calculated when there was an active region (with MAI > 100 G) in their vicinity, at 8° or less centre-to-centre, in comparison with quiet regions at the same solar disc location for which there were no neighbouring active regions (i.e., no region with MAI larger than 5 G) – Figure 3.

Figure 3: Examples of the logarithm of relative amplitude variation absolute value with distance for two different modes (adapted from Ref [3]). The dashed line shows a linear fit. The small red symbols give an indication of the noise level of the analysis.

Conclusion

After taking into account the nearby active regions, we did not find any amplification in the inferred mode amplitude due to flaring activity larger than a 10% uncertainty (Figure 4).


Figure 3: Figure 4: Mean relative-amplitude difference between flaring (Strong Flares, SF) and non-flaring regions (WO) with similar MAI in and around each region. Modes with n from zero to three are given by red, blue, green, and orange symbols. The error bars are the error of the mean for each mode. The mean relative-amplitude difference between pairs of two distinct groups of the Without Flare set is shown as black diamonds.


Thus, we conclude that if there were a change in the solar acoustic mode amplitudes due to the large energy released during a flare, the change must be small. We did not find any individual flaring region that had an increase in its mode amplitude outside the uncertainties in our analysis (i.e., 2.5 σ = 25% variation).

For details, see Ref. [2].

References

[1] [href="http://adsabs.harvard.edu/abs/1972ApJ...176..833W "Free Oscillations of the Sun and Their Possible Stimulation by Solar Flares"]

[2] [https://ui.adsabs.harvard.edu/abs/2021arXiv210213181R "Effects of flares on solar high-degree helioseismic acoustic mode amplitudes"]

[3] "Variations in p-Mode Parameters with Changing Onset Time of a Large Flare"

[4] "Statistical Analysis of Acoustic Wave Power and Flows around Solar Active Regions"

Personal tools
Namespaces
Variants
Actions
Navigation
Toolbox